Before you clear land in the Hill Country, check four things: whether a burn ban is active, the county’s burning conditions, oak wilt timing for any live oaks you keep, and local development rules for your parcel. Gillespie County publishes its burn ban status and burning requirements, Texas A&M Forest Service advises avoiding oak pruning and wounding from February through June, and the county engineer asks for a development determination before projects begin. This guide points to the primary sources. It is general information, not legal advice.
Land clearing rules at a glance
| Rule area | What the source says | Who to ask |
|---|---|---|
| Burn bans | Burn bans are ordered under Texas Local Government Code §352.081; never burn while one is active | Gillespie County Burn Ban page or fire marshal |
| Burning conditions (Gillespie County) | Outside city limits only; notify the Fredericksburg Fire Department first; start no earlier than 1 hour after sunrise and end no later than 1 hour before sunset; wind 6 to 23 mph; supervise at all times | County Burn Ban page |
| State outdoor burning | TCEQ publishes outdoor burning rules (30 TAC Chapter 111) and a residential do’s and don’ts brochure | TCEQ |
| Oak wilt | Avoid pruning or wounding oaks February through June | Texas A&M Forest Service |
| Development and flood plain | Development Permit Determination Form before development; flood hazard areas have added requirements | Gillespie County Engineering Department |
Burn bans and brush pile burning
Burning a brush pile can be the cheapest disposal option, but it is also the first one a burn ban removes. Check the county’s page the day you plan to burn, not the day you book the work. If burning is off the table, mulching leaves the material on the ground as chips, and hauling is the alternative. See brush pile burning and forestry mulching.
Oak wilt and live oak timing
Oak wilt spreads through fresh wounds on oak trees. Texas A&M Forest Service advises avoiding pruning or wounding oaks from February through June. When we clear cedar around live oaks, ask which oaks are keepers and when the work will happen.
Permits, flood plain and development
Texas counties have limited authority over land use in unincorporated areas (Local Government Code Chapter 233), so the answer changes by county and city. In Gillespie County the Engineering Department reviews a Development Permit Determination Form, which also checks flood plain exposure. Other Hill Country counties have their own offices. Call before you start grading near a creek or drainage.
What to do before clearing starts
- Look up the burn ban status for your county.
- Walk the land and flag live oaks, fence lines, gates and anything that stays.
- Decide the method and the debris plan: mulch, haul or burn.
- Ask the county or city whether your parcel needs a development determination.
- Schedule oak work outside February through June.
For pricing, read how much land clearing costs.
Get a written estimate for your clearing project
Call 830-268-6982 or send the details through our contact form: the size or acreage, what it will be used for, and the nearest town.
Land clearing rules questions
Can you burn brush in Gillespie County?
Only when no burn ban is active and the county’s conditions are met. Gillespie County’s requirements include burning outside city limits, notifying the Fredericksburg Fire Department first, burning only between one hour after sunrise and one hour before sunset, and supervising the fire at all times.
Is there a burn ban in Gillespie County today?
Check the county’s Burn Ban page before you light anything. Burn bans are ordered under Texas Local Government Code §352.081 and change with weather.
Can you burn brush in city limits?
Gillespie County’s requirements say to burn only outside the corporate limits of a city or town. Inside a city, ask the city fire department.
Do I need a permit to clear my own land in Texas?
We found no single state permit for clearing brush on private land in the sources below. Local rules still apply: Gillespie County’s Engineering Department asks for a Development Permit Determination Form before development, and flood plain areas have extra requirements.
When should oaks not be pruned or cut?
Texas A&M Forest Service advises avoiding pruning or wounding oaks from February through June because of the oak wilt risk. Plan oak work outside that window.
Sources
- Gillespie County: Burn Ban information and requirements
- TCEQ: Outdoor Burning
- Texas A&M Forest Service: Prevent the spread of oak wilt in Texas
- Texas Local Government Code Chapter 233
Checked November 8, 2026. Rules and burn ban orders change; confirm with the county before you act.